Teledyne 3010MA User Manual

Teledyne Analytical Instruments
i
OPERATING INSTRUCTIONS
Model 3010MA
Paramagnetic Oxygen Purity
Analyzer
DANGER
Toxic gases and or flammable liquids may be present in this monitoring system.
Personal protective equipment may be required when servicing this instrument.
Hazardous voltages exist on certain components internally which may persist for
a time even after the power is turned off and disconnected.
Only authorized personnel should conduct maintenance and/or servicing. Before
conducting any maintenance or servicing, consult with authorized
supervisor/manager.
P/N M3010MA
05/07/01
ECO# 01-0055

Teledyne 3010MA Specifications

General

Brand	Teledyne
Model	3010MA
Category	Analytical Instruments
Language	English

Summary

Safety Messages

Operational Theory

2.2 Electronics and Signal Processing

Explains the microcontroller, signal processing, and electronics within the Control Unit.

2.5 Temperature Control

Discusses the temperature control system ensuring thermal stability for accurate analysis.

Installation

3.3 Rear Panel Connections—Control Unit

Details the various connections on the rear panel of the Control Unit.

3.4 Installing the Analysis Unit

3.5 Rear Panel Connections—Analysis Unit

Operation

4.3 The System Function

4.4 The Zero and Span Functions

Describes the process of calibrating the analyzer using zero and span gases.

4.5 The Alarms Function

Covers the configuration of concentration and system failure alarms.

4.6 The Range Function

Explains how to set and manage the analyzer's concentration ranges.

Maintenance

5.2 Fuse Replacement

5.3 System Self Diagnostic Test

Explains how to initiate and interpret the analyzer's self-diagnostic tests.

Analysis Unit

6.2 Paramagnetic Sensor

Details the paramagnetic sensor, its principles of operation, and its characteristics.

6.3 Oven and Temperature Controller

Explains the oven and PID controller for maintaining sensor temperature stability.

6.4 Sample System

Describes the sample system, flow control, and pressure compensation.

6.5 Leak Checking the Analysis Unit

6.6 Initial Sensor Calibration

Outlines the initial sensor calibration procedure required before first use.

Appendix

A-1 Model 3010MA Specifications