Teledyne 3000TA User Manual

Teledyne Analytical Instruments
Trace Oxygen Analyzer
i
OPERATING INSTRUCTIONS FOR
Model 3000TA
Trace Oxygen Analyzer
P/N M62928
11/24/04
ECO: #03-0126
HIGHLY TOXIC AND OR FLAMMABLE LIQUIDS OR GASES MAY BE PRESENT IN THIS MONITORING
SYSTEM.
PERSONAL PROTECTIVE EQUIPMENT MAY BE REQUIRED WHEN SERVICING THIS SYSTEM.
HAZARDOUS VOLTAGES EXIST ON CERTAIN COMPONENTS INTERNALLY WHICH MAY PERSIST
FOR A TIME EVEN AFTER THE POWER IS TURNED OFF AND DISCONNECTED.
ONLY AUTHORIZED PERSONNEL SHOULD CONDUCT MAINTENANCE AND/OR SERVICING. BEFORE
CONDUCTING ANY MAINTENANCE OR SERVICING CONSULT WITH AUTHORIZED SUPERVISOR/
MANAGER.
DANGER

Teledyne 3000TA Specifications

General

Brand	Teledyne
Model	3000TA
Category	Analytical Instruments
Language	English

Summary

Introduction to the Model 3000TA Analyzer

Overview of the Trace Oxygen Analyzer

Provides a general introduction to the instrument and its purpose.

Typical Applications for the 3000TA

Lists common uses and industries for the analyzer.

Key Features of the 3000TA Analyzer

Details the main functional and design characteristics of the instrument.

Model Designations Explained

Clarifies different model variations of the 3000TA.

Front Panel Operator Interface Guide

Describes the controls and display on the instrument's front panel.

Rear Panel Equipment Interface

Details the connectors and ports on the instrument's rear panel.

Understanding the Model 3000TA Operational Theory

Introduction to Operational Theory

Outlines the analyzer's main subsystems and their functions.

Micro-Fuel Cell Sensor Principles

Explains how the oxygen sensor works, including its components and reactions.

Sample System Design and Function

Describes how the sample gas is handled and transported to the sensor.

Electronics and Signal Processing Overview

Details the internal electronics, including the microprocessor and signal conversion.

Installing the Model 3000TA Oxygen Analyzer

Unpacking and Inspecting the Analyzer

Instructions on how to unpack and check the instrument for damage.

Analyzer Mounting Procedures

Guidance on how to physically install the analyzer in its intended location.

Rear Panel Connections Overview

Details the primary ports and connectors on the instrument's rear panel.

Installing the Micro-Fuel Cell Sensor

Step-by-step guide for inserting the oxygen sensor.

System Testing and Verification

Procedures to confirm the analyzer is correctly installed and functional.

Operating the Model 3000TA Trace Oxygen Analyzer

Basic Operation and Function Buttons

How to navigate the menus and use the analyzer's controls.

System Configuration and Settings

Describes how to set up parameters like Auto-Cal, password, and alarms.

Zero and Span Calibration Procedures

Instructions for calibrating the analyzer using zero and span gases.

Alarm Configuration and Management

How to set and manage the instrument's alarm functions.

Range Settings and Output Signals

Configuring analysis ranges and understanding analog outputs.

Maintenance and Troubleshooting for the 3000TA

Routine Maintenance Tasks

Recommended regular checks and upkeep for the analyzer.

Replacing the Micro-Fuel Cell

Detailed steps for removing and installing a new oxygen sensor.

Fuse Replacement Guide

Instructions on how to replace blown fuses within the instrument.

System Self-Diagnostic Test

How to run the built-in diagnostic routine to check system health.

Troubleshooting Common Issues

Solutions for common problems like erratic readings or zeroing difficulties.

Appendices and Specifications

Technical Specifications of the 3000TA

Detailed performance and operational parameters of the analyzer.

Recommended Spare Parts List

A list of essential spare parts for the instrument.

Application Notes on Sample Flow and Pressure

Guidance on optimal sample flow rates and pressure considerations.

Material Safety Data Sheet (MSDS)

Information on the hazardous ingredients and safety precautions for the sensor.