Teledyne 3000TA-XL-EU User Manual

Trace Oxygen Analyzer
Teledyne Analytical Instruments i
OPERATING INSTRUCTIONS FOR
MODEL 3000TA-XL-EU
Trace Oxygen Analyzer
DANGER
Toxic gases and or flammable liquids may be present in this monitoring system.
Personal protective equipment may be required when servicing this instrument.
Hazardous voltages exist on certain components internally which may persist
for a time even after the power is turned off and disconnected.
Only authorized personnel should conduct maintenance and/or servicing.
Before conducting any maintenance or servicing, consult with authorized
supervisor/manager.
P/N M69603
9/24/10

Teledyne 3000TA-XL-EU Specifications

General

Brand	Teledyne
Model	3000TA-XL-EU
Category	Analytical Instruments
Language	English

Summary

Safety Information and Warnings

General Safety Notices

Important advisories and cautions for safe instrument operation.

Hazard Symbol Explanations

Explains standard warning symbols used throughout the manual.

Specific Hazard Warnings

Warnings pertaining to combustible gases and electrical hazards.

Operational Theory

Micro-Fuel Sensor Principles

Sensor Anatomy and Reactions

Pressure Effects and Calibration Characteristics

Sample System Function

Electronics and Signal Processing

Installation Guide

Unpacking and Mounting the Analyzer

Procedures for unpacking and physically installing the analyzer.

Rear Panel Connections

Details on connecting gas and electrical interfaces to the rear panel.

Gas Inlet and Outlet Connections

Specifics on sample and exhaust gas port connections.

Electrical Connections Overview

General requirements for safe electrical wiring.

Primary Power and Interface Connector

Analog Outputs and Alarm Relays

Digital Calibration Inputs and RS-232 Port

Remote Valve and Probe Connections

Installing the Micro-fuel Cell

System Testing Before Operation

Analyzer Operation

Introduction to Operation and Controls

Overview of operational modes and interface buttons.

System Function Configuration

Setting up Auto-Cal, passwords, logout, and self-tests.

Calibration Procedures

Detailed steps for zero and span calibration.

Sample Stream Switching and Alarms

Handling multiple gas streams and configuring alarm setpoints.

Range Configuration and Signal Outputs

Setting analysis ranges and understanding signal outputs.

IP Address Configuration

Setting the network IP address for web-enabled models.

Maintenance and Troubleshooting

Routine Maintenance Tasks

Cell and Fuse Replacement Procedures

System Self-Diagnostic Test

Major Internal Components and Cleaning

Troubleshooting Common Issues