What to do if the Teledyne Laboratory Equipment PurIon vacuum level is too low?
The Pirani pressure must be below 5.5E-3 mbar for the PurIon turbo pump to operate. This issue usually occurs if the roughing pump isn't turned on, especially after cleaning the capillary or changing the pump oil. Ensure the roughing pump is on.
What to do if no ion source is detected on Teledyne Laboratory Equipment PurIon?
The PurIon has reported that the ion source high voltage cable is not properly plugged into its socket. This is the cable with the round connector, located to the right and behind the ion source. This usually happens when changing or cleaning probes. Ensure the ion source high voltage cable is properly plugged into its socket.
Why Teledyne Laboratory Equipment PurIon has been shut down?
This message appears after the PurIon has been successfully shut down using the SHUTDOWN command. It's a reminder that an Rf reboot is needed for the PurIon to be enabled again by the Rf.
What to do if the ionization probe isn’t fully seated into the ion source housing of Teledyne Laboratory Equipment?
On PurIon systems (excluding PurIon S or PurIon L), if the ionization probe isn’t seated properly, loosen the thumbscrew on the front of the ion source housing, push down on the probe, and then tighten the thumbscrew.
What does error 310 mean for Teledyne Laboratory Equipment PurIon?
This error message is displayed if a plug is detected during a separation.
What does error 316 mean for Teledyne Laboratory Equipment PurIon?
This error occurs if the tubing is plugged while the method development screen is in use.
What causes the Teledyne Laboratory Equipment fluid interface pressure to be too low?
This could be due to lack of carrier fluid, loss of pump prime, or leakage.
Why Teledyne Laboratory Equipment PurIon temperatures are stabilizing?
The PurIon has several areas with heaters. The software uses a timer to allow temperatures to reach operating conditions. If the heaters aren't within an acceptable range after this time (default is 300 seconds after entering operate), a separate error is thrown. During standby, most heaters are OFF, except the inlet capillary, which is set to 50 C°.
General| Type | Automated Flash Chromatography System |
|---|---|
| Detection Method | UV-Vis |
| User Interface | Touchscreen |
| Solvent Channels | 4 |
| Pressure | 300 psi (20 bar) |
| Column Size Compatibility | 4g to 330g |
| Collection Modes | Peak-based, time-based, volume-based |
| Pump Type | Dual piston |
| Solvent Compatibility | Wide range of organic solvents |
Identifies and describes front, side, and back panel features and controls.
General safety warnings and hazard information for operating the instrument.
Steps for connecting the system to mains power.
Instructions for connecting solvent supply lines, excluding EZ Prep.
Guides on configuring system settings via the PeakTrak menu.
Procedure for priming the solvent lines before system operation.
Procedure for priming the solvent lines before system operation.
Instructions for configuring network settings, requiring IT administrator assistance.
Outlines a schedule for routine maintenance tasks to ensure safe operation.
Explains procedures for cleaning the flow cell to maintain performance.
Guides users on troubleshooting electrical issues like the touch panel being off.
To Next Page
