Need help?Do you have a question about the Teledyne GMI PS200 and is the answer not in the manual?
General| Operating Temperature | -20°C to +50°C |
|---|---|
| Ingress Protection | IP67 |
| Power Supply | Rechargeable Li-ion battery |
| Gases Detected | O2, CO, H2S, LEL |
| Alarms | Audible, Visual, Vibrating |
| Certifications | ATEX, IECEx, UL |
| Measurement Range | LEL: 0-100%, O2: 0-25%, CO: 0-1000 ppm, H2S: 0-100 ppm |
| Resolution | LEL: 1%, O2: 0.1%, CO: 1 ppm, H2S: 1 ppm |
| Output | Data logging |
Provides essential safety guidelines for using the monitor, emphasizing manual adherence.
Covers zero calibration errors during warm-up and operation, with troubleshooting.
Details sensor malfunction alerts and provides troubleshooting steps for different sensors.
Step-by-step guide for operating the gas monitor before use.
Procedure for powering on the gas monitor, including warm-up sequence.
Procedures for clearing or muting alarms, and understanding latching/non-latching.
General overview of gas alarm activation, types, and configurability.
Alarm for concentrations exceeding the LEL, indicating potential explosive conditions.
Verifies sensor response and alarm operation by exposing the monitor to known gas.
Steps to start a manual bump test, including confirmation and gas application.
Step-by-step guide to connecting the charging clip and recharging the monitor.
Overview of calibration procedures, options, and the importance of authorized personnel.
To Next Page
