To Next PageTo Next Page
Need help?Do you have a question about the Teledyne Echotrac E20 and is the answer not in the manual?
General| Type | Single beam echo sounder |
|---|---|
| Resolution | 1 cm |
| Ping Rate | Up to 30 Hz |
| Operating Temperature | -10°C to +50°C |
| Data Output | Ethernet, RS-232 |
| Power Consumption | 20 W |
| Interface | Ethernet, RS-232, RS-422 |
Provides a high-level overview of the Echotrac E20 echosounder system.
Details the main components and configuration of a typical Echotrac E20 survey system.
Highlights key functionalities like bottom detection, BITE, dual channel, and extended range.
Lists technical specifications for the Echotrac E20, including frequency, ping rate, power, and dimensions.
Details performance metrics such as accuracy, resolution, and depth range across different frequencies.
Explains the types of data output, including depth messages and echograms in s7k format.
Outlines essential safety guidelines for operating the Echotrac E20 and its transducer.
Provides precautions for handling, lifting, and connecting the echosounder and its components safely.
Describes methods for mounting the Echotrac E20 unit for tabletop or rack installation.
Details the rear panel cable connections and front panel interface of the Echotrac E20.
Covers general principles and specific methods for installing transducers on a vessel.
Guides the user through configuring the Echotrac E20 via the SBES User Interface software.
Guides the user through initial setup steps after configuration to prepare for operation.
Explains the different operational modes of the Echotrac E20 for survey acquisition.
Explains how to operate the E20 without a connected user interface for time-synchronized data.
Describes the status feedback and built-in alarms (BITE icons) provided by the SBES UI.
Addresses noise generated by propeller and appendage cavitation impacting sonar performance.
Covers potential interference from shipboard machinery and its proximity to the sensor.
Discusses interference from other echosounder systems and mitigation strategies.
Provides steps to diagnose and resolve issues when the Echotrac E20 is not functioning.
Guides on checking the power LED and troubleshooting when it is off.
Lists the default COM port settings required for communication with the Echotrac E20.
Covers safe handling, storage, and cleaning of the Echotrac E20 unit.
Guides on using the System Tool to update the Echotrac E20 software and use recovery mode.
Provides guidelines for handling, cleaning, and maintaining the echosounder transducer.
Covers proper handling, bend radius, and maintenance of power and data cables.
Lists additional available documentation for the Echotrac E20 system in PDF format.
Details the pinout and signal assignment for transducer connectors TX1 and TX2.
Shows the pinout and signal assignment for the serial COM ports (RS-232).
Outlines the pinout and signal assignment for the SYNC connector (trigger/PPS).
Details the pinout and signal assignment for the DC power input connector.
Identifies the LAN connector used for Ethernet communication.
Describes the universal message format for depth, heave, and draft data output.
Details the Single Bottom Tracking (SBT) string format for depth data.
Explains the Dual Bottom Tracking (DBT) string format for depth data with single or dual frequencies.
Outlines the depth data string format compatible with DESO25 echosounders.
Describes the NMEA 0183 DBS sentence format for depth data transmission.
Details the DESO DDV formats for heave, draft, and sound velocity data.
Outlines the terms and conditions of the standard one-year limited warranty for the system.
Provides contact information for customer support via phone and email.
Explains the procedure for obtaining authorization and returning equipment for service.
