Telefunken TX 101 - Remote Access and Base Unit Functions

TX Bluetooth 76
D. Remote access
Remote access allows you to operate your answering machine and listen to your messages by
calling your phone from another phone.
To set the remote access /change remote access code
1. In standby mode, MENU/OK then UP/DOWN to select Answering sys.
2. Press MENU/OK then UP/DOWN to select Ans sys setup.
3.Press MENU/OK then UP/DOWN to select Remote access.
4. Press MENU/OK then UP/DOWN to select On or Off.
5. Press MENU/OK to confirm.
If you set the remote access ON：
- Press MENU/OK. Use the keypad to enter the old 4-digit PIN (default 4-digit PIN is
0000).
- Press MENU/OK. Use the keypad to enter the new 4-digit PIN.
- Press MENU/OK to enter the new 4-digit PIN again.
- Press MENU/OK to confirm.
To remotely access your answering system
1. Dial your phone number, when you hear your outgoing message, press * and then enter
your 4 –digit Remote Access PIN when outgoing message is still playing.
2. If you enter the incorrect PIN code for 3 times, your phone will hang up automatically.
3. When you have accessed your phone, you can use the keypad to operate your answering
machine.
4. Press the keys below to perform the following functions:
Keys
Description
During Message Playback
Message is not playing
1
Play the remote access menu
2
Stop playing messages
Play messages
4
Press once to repeat playing the current
message from the beginning. Press twice
to skip backward to the previous
message.
5
Delete the current message
6
Skip forward
7
Turn on the answering
machine.
9
Turn off the answering
machine.
E. Using the answering machine at the base
Switch on/off
Press ANSWER ON to turn the answering system on or off. The light behind the key will be on
when answering system is turned on.
Call screening
You can listen at the telephone base to a caller leaving a message. If you want to turn off the call