You cannot take a picture from a phone that is in mobile telephone exchange. The command
must come from a private number or you must give the number explicitly in the command.
You must save users’ phone numbers in the phone directory before HouseControl can send
alarm messages to them (directory locations 1 – 5). Any valid user (1 – 20) can make setup
changes. All phone numbers must be stored in international format (beginning with +358 in
Finland).
If you want to change the unit’s settings from a phone number not listed in the directory, you
must first set the unit in programming mode by opening its cover.
If HouseControl does not send any text messages, the phone number for the SMS center
might be missing from the SIM card. An SMS center (SMSC) is responsible for handling the
SMS operations of a wireless network. You must program it with command SMSC nnnnn,
where nnnnn is the number for the SMS center.
You do not need this command if text messaging works without it.
HouseControl can be programmed to send a report at periodic intervals. To schedule a report,
use command REPORT d, where d is the interval in days (0 = never). For example, REPORT
14 means that report is sent every 14 days (2 weeks). The report is not sent at all by default.
If HouseControl is restarted, the report date is changed and it needs to be reprogrammed. The
report can be asked at any time by using the ? command.
P?
This returns the phone numbers in the directory. HouseControl will send more than
one text message if not all numbers fit into one text message.
NAME nnn
If you receive this symbol from HouseControl instead of an actual picture,
there are problems in the connection between the central unit and the remote
camera. Multimedia settings are correct and the GSM signal strength is
sufficient, but the problem is in the connection of the remote camera.
SMSC nnnnn
This sets the phone number for the SMS center
.
REPORT d
This schedules HouseControl to send a report at specified intervals
(0-30 days)
.
Px nnnnn
This saves the user’s phone number nnnnn in the phone directory
location x (1 – 20). The phone number must be stored in
international format. To clear a phone number from location x, just
leave out the phone number from the command.
To Next Page
Loading...
