Operating mode after power failure
You cannot change the operating mode if HouseControl is off; this might occur as a result of
prolonged power failure and discharged battery. HouseControl returns to the same mode it
was in before power failure when power is restored. If monitoring goes on and you move
inside the house, an unnecessary burglar alarm is generated.
Changing operating mode by phone call
You can also switch monitoring on or off by making a phone call to your HouseControl. You
will hear one or two beeps telling you what mode HouseControl will be in after YOU close
the call. One beep means monitoring will be on and two beeps mean monitoring will be off. If
you merely want to check the current operating mode and not change it, just wait until
HouseControl closes the call. In this case, the operating mode is not changed.
Behavior Unit status
One short blink
Monitoring is ON (All alarms are enabled). Switch
monitoring on when you leave home.
Two short blinks
Monitoring is OFF (Some of the alarms are disabled).
Switch monitoring off when you return home.
One long blink
Door security is on. Opening a door will result in an
alarm even though monitoring is off.
Blinks rapidly
The unit is in programming mode. Anyone can change
the unit’s settings in this mode. Programming mode goes
on when the unit’s cover is opened, and off when closed.
Light is on (no
blinking)
Error: the SIM card is placed improperly, the GSM
connection is not opened by your operator, the signal is
too weak, or the PIN code request is not disabled.
If you want to use HouseControl from a phone number that does not exist in the unit’s phone
directory, you must first set the unit in programming mode by opening its cover. Monitoring
must be switched off before you open the cover, otherwise an alarm will be generated.
HouseControl will be in programming mode when it is started up the first time. Anyone who
knows the unit’s phone number can send commands to it.
Activate door security from the left-hand side switch of the central unit before going to bed if
you want to make sure no one enters or leaves your home at night.
Remember to disable the door security from the same switch before opening the door the next
day. If burglar alarm is activated by mistake, you can silence the siren from the same switch or
by using a security keypad with proximity tag (in this case operating mode does not change).
Hold down for 2 seconds. Central unit’s status light will start blinking in 3
second cycles. Opening a door will now generate an alarm even though
monitoring is off.
OUTPUTS
To Next Page
Loading...