Telemic HouseControl E+ - System Operation and Commands; Basic Control and Keypad Usage

5
COMMANDS
Use text messages to control your HouseControl. HouseControl accepts commands only from
those phone numbers that have been entered in the unit’s phone directory. You can send only
one command in one text message. HouseControl replies with a text message.
There are two operating modes in HouseControl: either monitoring is on or off. Switch
monitoring on when you leave home and switch if off when you return. Some alarms are
disabled when monitoring is off.
When you are at home and monitoring is off you can activate so-called door security by
pressing the switch at the bottom of the central unit or by sending text message ALARM
DOOR. Command ALARM OFF sets door security off. Door security alarms if someone tries
to enter or leave the house, for example, at night time.
You can also switch monitoring on or off from security keypad in two different ways:
1. Press . Key in the four digit secret code provided with the installer’s proximity tag.
Press . If you want to change the secret code, please look for more information in
the Installation Manual.
2. Bring one of the proximity tags near the keypad (5-10cm) so that light flashes briefly.
Notice that you cannot change the operating mode with installer’s proximity tag.
Delays when using security keypad
When you switch monitoring on from the security keypad, the signal light starts blinking. You
have now 45 seconds to leave your home (close the door) or else burglar alarm will go.
When coming home you have 30 seconds to switch monitoring off from the security keypad
otherwise HouseControl activates burglar alarm. The aforementioned delays are not used
when operating mode is changed by a text message.
EN
CLR
?
Telemic HC
-
E
ALARM: OFF (Is monitoring on or off?)
CAMERA: OFF (Is camera enabled?)
BATT: 13.0 (Battery voltage)
IN: +23.1 (Indoor temperature)
OUT: -11.2 (Outdoor temperature)
WATER: +20.3 (Water temperature)
GSM: 19 (GSM signal strength 0-31,
should be at least 10 for sms, 15 for mms)
ALARMS: (Active alarms at the time of the question)
This command asks a report from your HouseControl.
?
COMMANDS
This lists all available commands. HouseControl returns the command
list also if it does not understand the received command.
Door security
Away
ALARM ON
At home
ALARM OFF
ALARM ON / OFF / DOOR
This text message command switches monitoring
on or off or sets door security on.
Continues on next page