INSTALLATION AND TESTING
Installation Manual contains detailed information about installation and testing of your HouseControl
and it comes with every HouseControl product.
You can test smoke detectors and carbon monoxide detectors according to the manufacturer’s
instructions (for example, using a test button). The test alarm must be at least 10 seconds long for
HouseControl to react to it. Notice that both sirens, the siren in the smoke detector and the siren
connected to HouseControl, must go on when there is an alarm. Exception: if interconnect feature is
enabled in the smoke detectors, every smoke detector siren should alarm.
You can silence the siren connected to HouseControl by flashing a proximity key near the security
keyboard or by pressing the door security button in HouseControl. Operating mode does not change
in these cases.
IMPORTANT! When testing HouseControl, it is important that every alarm that you receive is
acknowledged with message ALARM ON or ALARM OFF. The manufacturer does not guarantee the
delivery of SMS and MMS messages. These services are provided by your telecommunications
operator.
To Next Page
Loading...