Page 3
Installation Instructions
NOTE: SHOULD I USE THE REFLECTOR?
Using the reflector can greatly enhance the forward gain of an antenna, particularly indoors
where multipath reflections from bouncing signals cause reception issues. With a reflector,
interference from the rear is minimized and gain in the forward direction is increased,
resulting in better performance. However, antennas with reflectors need to be aimed
towards the direction of the towers. If the signal is very strong, going without a reflector
may be an option to increase omnidirectionality.
Nevertheless, it is generally recommended to use a reflector and aim the antenna towards
the transmitters for optimal performance, as broadcast television relies on line-of-sight
signal delivery.
Does a reflector improve reception for
both ATSC 1.0 and ATSC 3.0 signals?
YES.
Should the reflector be used
outdoors too?
YES.
zzz
TABLE MOUNT (WITH REFLECTOR)
Step 1
Remove the pole mounting hardware from the
Reflector (E) using the included Wrench (J).
Step 2
Place the Reflector (E) in the position shown
below and fasten with included Screws (D).
Fully Assembled for Table Mount
Continue on page 5 with Connection Steps.
To Next Page
Loading...
