TG-7 Cellular Series Installation & Operating Guide 13 56053501 Rev A © 2022 Telguard
Getting Ready
The communicator can only be activated when all necessary accounting information has been added
to the TCC customer database (i.e., the unit has been registered). The database includes information
about the customer account, unit location, and system test plan information.
Dealer Account Establishment
A Dealer Account must be established prior to registration of any Telguard unit. This can be
accomplished by visiting telguard.com and completing
Signup This is a one-time event and an acknowledgment from Telguard Customer Service will
include a Dealer Account Number that will be used for all Telguard Digital registrations. Telguard
units can be registered and activated once the Dealer Account has been established.
Pre-Installation Checklist
Before attempting to connect the communicator to the alarm panel, please make sure you have all the
proper parts prior to going to the job site. The following items are shipped with each TG-7 Cellular
Series product:
• Telguard Cellular Communicator
• Cellular Antenna
• Antenna Extension Cable and Mounting Bracket
• AC Power Adapter
• Battery Connection Cable
• Telco Connection Cable
• Pluggable Screw Terminal Blocks (2-, 2-, 3-, & 6- position)
• Enclosure Key
• Quick Install Guide
• Frequency Warning Label to be applied for installations in Canada (AT&T models only)
• Tamper Switch Easy-Attach Assembly (TG-7 and TG-7A only or when purchased as an accessory)
Note: When upgrading an existing communicator using the TG-7UB, continued use of some existing
items is necessary. See the instructions provided with the TG-7UB for further details.
To Next Page
