TG-7 Cellular Series Installation & Operating Guide iv 56053501 Rev A © 2022 Telguard
Table of Contents
Important Note i
Foreword i
Technical Support i
About this Manual i
Repair and Warranty ii
Future Testing and Limitations on Use ii
Terms and Conditions for Use of Telguard Product ii
INDEMNIFICATION OF TELGUARD
WARRANTY and LIMITATIONS
General Description and Operation 1
Information Related to Software Settings Fire Systems 3
Information Related to Software Settings Burglary Systems 5
Features 7
Operating Mode 7
Multiple Alarm Format Support 7
Complete Supervision of Communication Path 7
Link Supervision and Standard Line Security 8
Complete Power Supervision 9
Telguard Automatic Self-Test Report 9
Programmable Supervisory Trip Output (STC) Relays 10
Post-Installation Remote Programming 11
Diagnostic and Status LEDs 11
Optional DC Operation (12VDC or 24VDC) 11
Complete Factory Reset Option 11
UL and ULC Compliance 12
Getting Ready 13
Dealer Account Establishment 13
Pre-Installation Checklist 13
PCB Layout 14
Installation 15
Summary 15
Step 1: Register the Communicator 15
Select the Mode of Operation
UL/ULC Commercial Fire Sole Path (Cellular Only Mode) Features
Decide on a STC Trip Output Strategy
Optional Trip Input
Step 2: Physically Install the Communicator in Desired Location 17
Identify Location for Placing the Communicator and Mount
Install Optional TG-PEM Accessory into Enclosure (if using)
Complete All Power-Related Wiring Connections
To Next Page
Loading...
