TG-7 Cellular Series Installation & Operating Guide v 56053501 Rev A © 2022 Telguard
Step 3: Determine Antenna Placement for Best Performance 18
Connect Antenna
Measure Received Signal Strength (RSSI)
Optimizing Antenna Performance
Step 4: Make Communications Connections and Activate 19
Special LED Indications During Activation
Verify Alarm Signal Transmissions Over Cellular Path
Step 5: Connect Supervisory Trip Outputs 20
Reprogram Alarm Panel to Send Proper Code
Check Proper Operation of Supervisory Output
Step 6: Connect Tamper Switch (required for burg/optional in fire-only systems) 21
Mandatory for Commercial Burg Use
Optional Use or As Required by AHJ
Optional: Connect and Test the Trip Input 21
Appendix 1 Connection Guide 23
Wiring Diagrams 23
Telco Connection through the Communicator (Backup or Primary Mode)
Cellular-Only Wiring (When Communicator is Only Path Used)
Cellular-Only Wiring (With Telco Connection Through Second Panel DACT)
Tamper Switch Installation 27
RJ-45 Jack Pin Assignments 28
DC Terminal Strip Pin Assignments 28
Main Terminal Strip Pin Assignments 28
AC Terminal Strip Pin Assignments 29
Compatible Alarm Panels 29
Appendix 2 Troubleshooting Guide 30
LED Indicator Guide Normal Operating Mode 30
Troubleshooting Quick Reference Table 31
LED Indicator Guide RSSI Mode 32
Appendix 3 Commercial Fire Single DACT Installation 33
Cellular Signal Strength 33
Configure Fire Alarm Panel to Use Single Communication Device 33
Appendix 4 Commercial Fire 6-hour Supervision 34
Appendix 5 Compliance with UL and ULC Standards 34
Appendix 6 Detailed Specifications 35
Dialer to Interface Electronics 35
Power Requirements 35
Field Wiring Electrical Ratings
Power Limited Circuits
System Faults Impedance
Digital Cellular Radio and Other Specifications 35
Appendix 7 Accessories 36
To Next Page
Loading...
