TG-7 Cellular Series Installation & Operating Guide 14 56053501 Rev A © 2022 Telguard
The following items may be needed and are not included with the communicator:
• Screws or nails for mounting the communicator enclosure and antenna to the wall
• Solid or stranded electrical wire for connecting the STC relay outputs, trip input, or tamper to the
alarm panel. The terminal blocks can accommodate solid or stranded 16 to 22 gauge wire.
• Conduit and connectors for protecting wiring
• Lead acid backup battery (7Ah recommended/4Ah minimum) when installation will use the AC
power adapter
Finally, certain installation and testing tools may be needed or helpful:
• Screwdrivers for mounting and making connections
• Standard telephone or lineman's butt-set for verifying communication between the panel and the
communicator
NOTE: The communicator registration must be completed in advance to avoid installation delays
PCB Layout
To Next Page
