Telguard TG-7FP Installation & Operating Guide iv 56052401 Rev A
Table of Contents
Important Note i
Foreword i
General Description and Operation 1
Information Related to Software Settings 2
Features 4
Operating Mode 4
Multiple Alarm Format Support 4
Complete Supervision of Communication Path 4
Link Supervision 5
Complete Power Supervision 5
Telguard Automatic Self-Test Report 6
Telguard Check Status Capability 6
Programmable Supervisory Trip Output (STC) Relays 6
Post-Installation Remote Programming 7
Diagnostic and Status LEDs 7
Complete Factory Reset Option 7
UL and ULC Compliance 8
Getting Ready 8
Dealer Account Establishment 8
Pre-Installation Checklist 8
Installation 9
Summary 9
Step 1: Register the Telguard Communicator 9
Step 2: Physically Install the TG-7FP in Desired Location 10
Step 3: Determine Antenna Placement for Best Performance 11
Step 4: Connect to Panel DACT and Activate 12
Step 5: Connect Supervisory Trip Outputs 13
Step 6: Connect and Test the Trip Input (optional) 14
Step 7: Connect Tamper Switch (optional in fire-only systems/required for burg) 14
To Next Page
Loading...
