Telit Wireless Solutions HE863 Series - Page 108

HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 108 of
229
+CPMS - Preferred Message Storage
reading, writing and storing respectively.
AT+CPMS=?
Test command reports the supported values for parameters <mem1>, <mem2> and
<mem3>
Example AT+CPMS?
+CPMS: "ME",27, 50,"ME",27, 50,"SR",1,20
OK
AT+CPMS="SM","ME","SM"
+CPMS: 1,20,27, 50,1,20
OK
AT+CPMS?
+CPMS: "SM",1,20,"ME",27, 50,"SM",1,20
OK
Reference 3GPP TS 27.005
3.5.4.1.3. Message Format - +CMGF
+CMGF - Message Format
AT+CMGF=
[<mode>]
Set command selects the format of messages used with send, list, read and write
commands.
Parameter:
<mode>
0 - PDU mode, as defined in 3GPP TS 3.40/23.040 and 3GPP TS 3.41/23.041
(default)
1 - text mode
AT+CMGF?
Read command reports the current value of the parameter <mode>.
AT+CMGF=?
Test command reports the supported value of <mode> parameter.
Example AT+CMGF=1
OK
Reference 3GPP TS 27.005