HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 109 of
229
3.5.4.2. Message Configuration
3.5.4.2.1. Service Center Address - +CSCA
+CSCA -Service Center Address
AT+CSCA=
<sca>
[,[<tosca>]]
Set command sets the Service Center Address to be used for mobile originated SMS
transmissions.
Parameter:
<sca> - string indicating the service center address, as a GSM 04.11 RP SC address
Address-Value field in
string format (i.e., enclosed by quotes ““), BCD numbers (or GSM default alphabet
characters) are converted to
characters.
<tosca> - GSM 04.11 RP SC address Type-of-Address octet in integer format.
When this parameter is omitted, If the first character of sca is ‘+’ (IRA 43) default
is 145, otherwise default is 129).
Note: to use the SM service, is mandatory to set a Service Center Address at which
service requests will be directed.
Note: in Text mode, this setting is used by send and write commands; in PDU
mode, setting is used by the same commands, but only when the length of the
SMSC address coded into the <pdu> parameter equals zero.
Note: the current settings are stored through +CSAS
AT+CSCA?
Read command reports the current value of the SCA in the format:
+CSCA: <sca>,<tosca>
AT+CSCA=?
Test command returns the OK result code.
Example AT+CSCA="01029190903",129
OK
AT+CSCA?
+CSCA: "01029190903",129
OK
Reference 3GPP TS 27.005
3.5.4.2.2. Select service for MO SMS services - +CGSMS
+CGSMS – Select service for MO SMS messages
AT+CGSMS=
[<service>]
The set command is used to specify the service or service preference that the MT wi
ll use to send MO SMS messages.
Parameters:
<service> -a numeric parameter which indicates the service or service preference to
be used.
To Next Page
Loading...
