HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 111 of
229
3.5.4.2.4. Show Text Mode Parameters - +CSDH
+CSDH - Show Text Mode Parameters
AT+CSDH=
[<show>]
Set command indicates whether detailed header information is shown in text mode
result codes or not.
Parameter:
<show>
0 - do not show header values defined in commands +CSCA and +CSMP (<sca>,
<tosca>, <fo>, <vp>, <pid> and <dcs>) nor <length>, <toda> or <tooa> in
+CMT, +CMGL, +CMGR result codes for SMS-DELIVERs and SMS-
SUBMITs in text mode. For SMS-COMMANDs in +CMGR result code do not
show <pid>, <mn>, <da>, <toda>, <length> or <cdata>
1 - show the values in result codes
AT+CSDH?
Read command reports the current setting in the format:
+CSDH: <show>
AT+CSDH=?
Test command reports the supported range of values for parameter <show>
Reference 3GPP TS 27.005
To Next Page
Loading...
Need help?
General
