HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 112 of
229
3.5.4.2.5. Select Cell Broadcast Message Types - +CSCB
+CSCB -Select Cell Broadcast Message Types
AT+CSCB=
[<mode>[,<mids>
[,<dcss>]]]
Set command controls which CB messages are accepted and those that are rejected.
Parameters:
<mode> - control whether message types that are specified are going to be accepted
or rejected
0 - the message types defined by <mids> and <dcss> are accepted (factory
default)
1 - the message types defined by <mids> and <dcss> are not accepted
<mids> - Message Identifiers, string type: all different possible combinations of the
CBM message identifiers; default is empty string (“”).
<dcss> - Data Coding Schemes, string type: all different possible combinations of
CBM data coding schemes; default is empty string (“”).
Note: the current settings are stored through +CSAS
AT+CSCB?
Read command reports the current value of parameters <mode>, <mids> and
<dcss>.
AT+CSCB=?
Test command returns the range of values for parameter <mode>.
Example AT+CSCB=0, "0,1,5,320-478,922","0-3,5"
OK
AT+CSCB?
+CSCB: 0,"0,1,5,320-478,922","0-3,5"
OK
Reference 3GPP TS 27.005, 3GPP TS 03.41/23.041, 3GPP TS 03.38/23.038.
3.5.4.2.6. Save Settings - +CSAS
+CSAS - Save Settings
AT+CSAS
[=<profile>]
Execution command saves settings which have been made by the +CSCA, +CSMP
and +CSCB commands in local volatile memory.
Parameter:
<profile>
0 - it saves the settings to NVM (factory default).
1..n - SIM profile number; the value of n depends on the SIM and its max is 3.
Note: certain settings may not be supported by the SIM and therefore they are
always saved to NVM, regardless the value of <profile>.
AT+CSAS=?
Test command returns the possible range of values for the parameter <profile>.
Reference 3GPP TS 27.005
3.5.4.2.7. Restore Settings - +CRES
+CRES - Restore Settings
To Next Page
Loading...
Need help?
General
