HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 116 of
229
+CNMI - New Message Indications To Terminal Equipment
<PDU> - message PDU
(TEXT Mode)
+CBM:<sn>,<mid>,<dcs>,<pag>,<pags><CR><LF><data>
where:
<sn> - message serial number
<mid> - message ID
<dcs> - Data Coding Scheme
<pag> - page number
<pags> - total number of pages of the message
<data> - CBM Content of Message
If <dcs> indicates that GSM03.38/23.038 default alphabet is used ,
each character of GSM/WCDMA alphabet will be converted into
current TE character set (see +CSCS)
If <dcs> indicates that 8-bit or UCS2 data coding scheme is used, each 8-bit
octet will be converted into two IRA character long hexadecimal number (e.g. octet
0x2A will be converted as two characters 0x32 0x41)
3 - Class 3 CBMs are routed directly to TE using unsolicited result codes defined
in <bm>=2. If CBM storage is supported, messages of other classes result in
indication as defined in <bm>=1.
<ds> - SMS-STATUS-REPORTs reporting option
0 - status report receiving is not reported to the DTE and messages are stored
1 - the status report is sent to the DTE with the following unsolicited result code:
(PDU Mode)
+CDS: <length><CR><LF><PDU>
where:
<length> - PDU length
<PDU> - message PDU
(TEXT Mode)
+CDS: <fo>,<mr>,<ra>,<tora>,<scts>,<dt>,<st>
where:
<fo> - first octet of the message PDU
<mr> - message reference number
<ra> - recipient address, string type.
<tora> - type of number <ra>
<scts> - arrival time of the message to the SC
<dt> - sending time of the message
<st> - message status as coded in the PDU
2 - if a status report is stored, then the following unsolicited result code is sent:
+CDSI: <mem1>,<index>
where:
<mem1> - memory storage where the new message is stored
"SR"
To Next Page
Loading...
Need help?
General
