HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 117 of
229
+CNMI - New Message Indications To Terminal Equipment
<index> - location on the memory where SMS is stored
<bfr> - buffered result codes handling method:
0 - TA buffer of unsolicited result codes defined within this command is flushed to
the TE when <mode>=1..2 is entered
1 - TA buffer of unsolicited result codes defined within this command is cleared
when <mode>=1..2 is entered.
AT+CNMI?
Read command returns the current parameter settings for +CNMI command in the
form:
+CNMI: <mode>,<mt>,<bm>,<ds>,<bfr>
AT+CNMI=?
Test command reports the supported range of values for the +CNMI command
parameters.
Reference 3GPP TS 27.005
Example AT+CMGF=1
OK
AT+CNMI=1,2,0,1,0
OK
Received message from network
+CMT: "+821020955219",,"07/07/26,20:09:07+36"
TEST MESSAGE
3.5.4.3.2. List Messages - +CMGL
+CMGL - List Messages
AT+CMGL
[=<stat>]
Set command displays message with status value <stat> or all messages from
message storage <mem1> to the TE
The parameter type and the command output depend on the last settings of
command +CMGF (message format to be used)
(PDU Mode)
Parameter:
<stat>
0 - new message
1 - read message
2 - stored message not yet sent
3 - stored message already sent
4 - all messages.
Each message to be listed is represented in the format:
+CMGL: <index>,<stat>,<alpha>,<length><CR><LF><pdu>
where:
<index> - message position in the memory storage list.
<stat> - status of the message
To Next Page
Loading...
Need help?
General
