EasyManuals Logo

Telit Wireless Solutions HE863 Series User Manual

Telit Wireless Solutions HE863 Series
229 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #133 background imageLoading...
Page #133 background image
HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 133 of
229
#SRS - Select Ringer Sound
AT#SRS=
[<n>,<tout>]
Set command sets the ringer sound.
Parameters:
<n> - ringing tone
0 - current ringing tone
1..max - ringing tone number, where max can be read by issuing the Test
command AT#SRS=?.
<tout> - ringing tone playing time-out in seconds.
0 - ringer is stopped (if present) and current ringer sound is set.
1..60 - ringer sound playing for <tout> seconds and, if <n> > 0, ringer sound <n>
is set as default ringer sound.
Note: when the command is issued with <n> > 0 and <tout> > 0, the <n> ringing
tone is played for <tout> seconds and stored as default ringing tone.
Note: if command is issued with <n> > 0 and <tout> = 0, the playing of the ringing
is stopped (if present) and <n> ringing tone is set as current.
Note: if command is issued with <n> = 0 and <tout> > 0 then the current ringing
tone is played.
Note: if both <n> and <tout> are 0 then the default ringing tone is set as current
and ringing is stopped.
Note: If all parameters are omitted then the behaviour of Set command is the same
as Read command
AT#SRS?
Read command reports current selected ringing and its status in the form:
#SRS: <n>,<status>
where:
<n> - ringing tone number
1..max
<status> - ringing status
0 - selected but not playing
1 - currently playing
AT#SRS=?
Test command reports the supported values for the parameters <n> and <tout>
3.5.5.1.3. Select Ringer Path - #SRP
#SRP - Select Ringer Path
AT#SRP=[<n>]
Set command selects the ringer path towards whom sending ringer sounds and all
signalling tones.
Parameter:
<n> - ringer path number
0 - sound output towards current selected audio path (see command
#CAP)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions HE863 Series and is the answer not in the manual?

Telit Wireless Solutions HE863 Series Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelHE863 Series
CategoryControl Unit
LanguageEnglish

Related product manuals