HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 134 of
229
#SRP - Select Ringer Path
AT#SRP?
Read command reports the selected ringer path in the format:
#SRP: <n>.
AT#SRP=?
Test command reports the supported values for the parameter <n>.
Example AT#SRP=?
#SRP: (0)
OK
AT#SRP=0
OK
3.5.5.1.4. Signalling Tones Mode - #STM
#STM - Signaling Tones Mode
AT#STM=
[<mode>]
Set command enables/disables the signalling tones output on the audio path selected
with #SRP command
Parameter:
<mode> - signalling tones status
0 - signalling tones disabled
1 - signalling tones enabled
2 – all tones disabled
Note: AT#STM=0 has the same effect as AT+CALM=2;
AT#STM=1 has the same effect as AT+CALM=0.
AT#STM?
Read command reports whether the current signaling tones status is enabled or not,
in the format:
#STM: <mode>
AT#STM=?
Test command reports supported range of values for parameter <mode>.
3.5.5.1.5. Tone Playback - #TONE
#TONE - Tone Playback
AT#TONE=<tone>
[,<duration>]
Execution command allows the reproduction of DTMF tones, standard free tone,
standard busy tone, and a set of user defined tones for a certain time.
Parameters:
<tone> - ASCII characters, range is ((0-9),#,*,(A-D),(G-L),Y,Z);
- (0-9), #,*,(A-D): DTMF tone
- (G-L): User Defined Tones
- Y: free tone
- Z: busy tone
<duration> - playback duration in 1/10 sec.
1..300 - tenth of seconds (default is 30)
AT#TONE=?
Test command returns the supported range of values for parameters
To Next Page
Loading...
Need help?
General
