HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 226 of
229
+STKENV – SIMTOOLKIT Envelop command
<help_requested> indicates help requested and may be:
- 1: help is requested
- 0: help is not requested
<language> currently used language in the DTE (coding see 11.14)
AT+STKENV=?
Test command returns the OK result code
3.5.5.5.5. SIMTOOLKIT terminal Profile - +STKPROF
+STKPROF – SIMTOOLKIT terminal Profile
AT+STKPROF=<lengt
h>,<data>
This command allows reading and changing the terminal profile data. The terminal profile
sent by external STK client states the facilities relevant to SIM Application Toolkit that is
supported.
Parameters:
<length>: integer type value; length of the characters that are sent to TE in <data>
Note: <length> set to 0 forces a reset to the default terminal profile stored in the ME.
<data>: terminal profile data coded in hex format.
AT+STKPROF?
Read command returns the simtoolkit profile list
SAT Terminal Profile according to 3GPP TS 31.114, i. e. the list of SIM
Application Toolkit facilities that are supported by the ME. The profile cannot
be changed by the TA.
+STKPROF: <length>,<data>
e.g. +STKPROF=4,”1F7F”
OK
AT+STKPROF=?
Test command returns the OK result code
To Next Page
Loading...
Need help?
General
