EasyManuals Logo

Telit Wireless Solutions HE863 Series User Manual

Telit Wireless Solutions HE863 Series
229 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 31 of 229
+FCLASS - Select Active Service Class
8 - voice
AT+FCLASS?
Read command returns the current configuration value of the parameter <n>.
AT+FCLASS=?
Test command returns all supported values of the parameters <n>.
Note “ATD<number>;” (end with semicolon) will initiate voice call no matter which
connection mode is set by +FCLASS.
Reference 3GPP TS 27.007
3.5.2.1.4. Default Reset Basic Profile Designation - &Y
&Y - Default Reset Basic Profile Designation
AT&Y[<n>]
Execution command defines the basic profiles which will be loaded on startup.
Parameter:
<n>
0..1 - profile (default is 0): the wireless module is able to store 2 complete
configurations (see &W).
Note: differently from command Z<n>, which loads just once the desired profile,
the one chosen through command &Y will be loaded on every startup.
Note: if parameter is omitted, the command has the same behaviour as AT&Y0
3.5.2.1.5. Default Reset Full Profile Designation - &P
&P - Default Reset Full Profile Designation
AT&P[<n>]
Execution command defines which full profile will be loaded on startup.
Parameter:
<n>
0..1 – profile number: the wireless module is able to store 2 full configurations
(see command &W).
Note: differently from command Z<n>, which loads just once the desired profile,
the one chosen through command &P will be loaded on every startup.
Note: if parameter is omitted, the command has the same behaviour as AT&P0
Reference Telit Specifications
3.5.2.1.6. Store Current Configuration - &W
&W - Store Current Configuration
AT&W[<n>]
Execution command stores on profile <n> the complete configuration of the device.
Parameter:
<n>

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions HE863 Series and is the answer not in the manual?

Telit Wireless Solutions HE863 Series Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelHE863 Series
CategoryControl Unit
LanguageEnglish

Related product manuals