Telit Wireless Solutions HE863 Series - Page 32

HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 32 of 229
&W - Store Current Configuration
0..1 - profile
Note: if parameter is omitted, the command has the same behaviour of AT&W0.
3.5.2.1.7. Manufacturer Identification - +GMI
+GMI - Manufacturer Identification
AT+GMI
Execution command returns the manufacturer identification.
AT+GMI=?
Test command returns OK result code.
Reference V.25ter
3.5.2.1.8. Model Identification - +GMM
+GMM - Model Identification
AT+GMM
Execution command returns the model identification.
AT+GMM=?
Test command returns OK result code.
Reference V.25ter
3.5.2.1.9. Revision Identification - +GMR
+GMR - Revision Identification
AT+GMR
Execution command returns the software revision identification.
AT+GMR=?
Test command returns OK result code.
Reference V.25ter
3.5.2.1.10. Capabilities List - +GCAP
+GCAP - Capabilities List
AT+GCAP
Execution command returns the equipment supported command set list.
Where:
+CGSM: 3GPP TS command set
+FCLASS: Fax command set
+DS: Data Service common modem command set
+ES: WCDMA data Service common modem command set
+MS: Mobile Specific command set
AT+GCAP=?
Test command returns OK result code.
Reference V.25ter
3.5.2.1.11. Serial Number - +GSN
+GSN - Serial Number
AT+GSN
Execution command returns the device IMEI.
Note: The number returned from the same command in Telit GC series is board