EasyManua.ls Logo

Telstra T96 - RF Safety Information; Radio Frequency Energy

Telstra T96
53 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
52
LIMITATION OF LIABILITY
ZTE shall not be liable for any loss of profits or indirect, special,
incidental or consequential damages resulting from or arising out of or in
connection with using this product, whether or not ZTE had been advised,
knew or should have known the possibility of such damages. Refer to the
enclosed warranty card for full warranty and service information.
RF SAFETY INFORMATION
The handset has an internal antenna located at the top of the phone. For
optimum performance with minimum power consumption do not cover
the antenna area with your hand. Hold the handset between thumb and
finger in the middle of the device. Covering the antenna affects call
quality, may cause the handset to operate at higher power level than
needed, and may shorten talk and idle times.
RADIO FREQUENCY ENERGY
The handset is a low-power radio transmitter and receiver. When
switched on it intermittently transmits radio frequency (RF) energy (radio
waves). The transmit power level is optimized for best performance and
automatically reduces when there is good quality reception. Maximum
power is only used at the edge of network coverage so under most
circumstances the power output is very low. Under poor network
conditions the phone transmits at a higher power, may get hot and have a
significantly shorter battery life.

Other manuals for Telstra T96

Related product manuals