Default configuration settings
Movement and ignition detection:
Vehicle movement will be detected
by accelerometer
Ignition will be detected by
vehicle power voltage
between 13,2 – 30 V
Device makes a record On Moving if one of these events happen:
300 seconds passes Vehicle turns 10° degrees
Vehicle drives 100 meters
Speed difference between
last coordinate and current
position is greater than 10
km/h
Device makes a record On Stop if:
1 hour passes while vehicle is
stationary and ignition is off
Records sending to server:
If device has made a record it is
sent to the server every 120
seconds
After successful SMS configuration, FMC150 device will synchronize time and update records to
configured server. Time intervals and default I/O elements can be changed by using Teltonika
Configurator or SMS parameters.
FMC150 Configuration Upload
FMC150 CAN configuration can be uploaded Over The Air by using FOTA WEB.
In order to download your vehicles CAN configuration please follow a quick and simple step-
by-step guide below. FMC150 device, must be registered in FOTA WEB – device‘s model,
firmware version, serial number, and other information must be shown.
Select the devices by clicking the check-box next to them1.
Press "Create task" at the top-left corner of the page2.
Select „Upload CAN configuration“ task type3.
Select Vehicle Make, and Model :4.
To Next Page
Loading...
