Temcoline T30 SERIES User Manual

www.temcoline.com
DIGITAL PID CONTROLLER
24
Initial value
Initial value
Display
Display
Description
Description
Setting range
Setting range
Condition
Condition
In/output setting mode
OFF / 1 ~ 20
(See alarm type)
1 ~ 33
(refer to P7, 2. 1)
EUS (0.0 ~ 100.0 %)
0 ~ 3
(refer to P8, 2. 2)
EUS (0.0 ~ 100.0 %)
OFF / ON
OFF / 1~240 sec.
OFF / 1~240 sec.
OFF / ON
2
1
EUS (0.5%)
1
OFF
EUS (0.5%)
OFF
PV
OFF
OFF
OFF
Using alarm
1, 2 option
Always
Always
Always
Using alarm1
(1~20)
Using alarm2
Using alarm1
Using alarm2
Using
DI option
Using
RET option
Always
-
- -
PV/ SV/ MV/ SPS
OFF/ ON/ ALL
Select alarm 1 output type
Input type selection (_InP)
Hysteresis of alarm 1 output
Output type selection (_out)
Hysteresis of alarm 2 output
Manipulated variable (_Mvn)
Display setting
Delay time of alarm 1
Delay time of alarm 2
External contact input (SV1, 2)
ON/OFF switch
Retransmission type
or SPS selection
Set data protection
3) In/Output setting mode
The input/output setting mode is a parameter for the first time use. It's a
hardware configuration so requires special user caution. That is, the
configuration is determined by the type of equipment and it must be
configured first. (※ all parameters are initialized according to the entered
input type.)
When the input type is changed, all parameters are reverted to their
factory default. This means that before using the T30, the input
type needs to be set first, after which other parameters can be
configured. If the input settings are changed while in use,
auto-tuning and other parameters need to be reconfigured.
When the input type is changed, all parameters are reverted to their factory default.
This means that before using the T30, the input type needs to be set first, after
which other parameters can be configured. If the input settings are changed while
in use, auto-tuning and other parameters n eed to be reconfigured.

Temcoline T30 SERIES Specifications

General

Brand	Temcoline
Model	T30 SERIES
Category	Controller
Language	English