www.temcoline.com
DIGITAL PID CONTROLLER
20
3) Set value(SV) setting [ in condition of Mvn = OFF (basic) ]
4) Auto tuning
AT command lamp (flash every 0.5 sec.)
Auto-tuning is required before operating for the first time. Set the target value(SV) in the
range
mainly used and run auto-tuning. When auto-tuning begins, the "auto-tuning command
lamp"
will flash every 0.5 second and will turn off upon completion of the auto-tuning
process.
Please refrain from operating the keys while auto-tuning is in progress.
① Enter to setting mode by key
② Set a desired value by key
③ Store a value by key
AT operation start : + 0.5 second
AT stop by perforce : + 0.5 second
To Next Page
Loading...
