Need help?Do you have a question about the Temcoline T30 SERIES and is the answer not in the manual?
General| Brand | Temcoline |
|---|---|
| Model | T30 SERIES |
| Category | Controller |
| Language | English |
Details model dimensions, sizes, and available options for T30 series controllers.
Explains standard control modes like Heating or Cooling available for the T30 series.
Lists optional functions available for different T30 series models, such as specific outputs.
Specifies power supply options (100-240V AC, 24V AC/DC) and their usage conditions.
Illustrates how to construct a T30 series model number based on selected options.
Covers various input types (TC, RTD, Voltage, Current) and their setting codes/ranges.
Details output types (Relay, SSR, SCR) and their corresponding setting numbers and functionalities.
Provides physical dimensions and panel cutout details for the T32 model.
Provides physical dimensions and panel cutout details for the T33 model.
Provides physical dimensions and panel cutout details for the T34 model.
Provides physical dimensions and panel cutout details for the T37 model.
Provides physical dimensions and panel cutout details for the T39 model.
Step-by-step guide for installing the T34 series controller into a panel.
Step-by-step guide for installing T32, T33, T37, T39 series controllers into a panel.
Shows terminal layouts and wiring diagrams for T32 and T33 models.
Details terminal layouts and wiring diagrams for the T34 model, including options.
Shows terminal layouts and wiring diagrams for the T37 model.
Shows terminal layouts and wiring diagrams for the T39 model.
Explains the function of the PV display, shown in red.
Describes the AT lamp's behavior during the auto-tuning process.
Explains the SV display, shown in green, for set values, codes, and modes.
Indicates when the control output is ON.
Illuminates when the SV2 value is being displayed.
Lights up when an alarm condition is active.
Used for menu navigation, storing values, and operating the device.
Allows shifting digits for setting values.
Decreases set values and moves through menus.
Increases set values and moves through menus.
Specifies the default input and output settings at the time of manufacture.
Shows the character set displayed on the 7-segment indicators.
Illustrates the initial display and key indications when the controller is powered on.
Detailed safety warnings to prevent serious injury or death if instructions are not observed.
Detailed safety cautions to prevent instrument damage or injury if instructions are not observed.
Guides users on setting the appropriate input sensor and output signal types.
Explains how to view the control output percentage (MV) on the SV display.
Details how to reconfigure input/output settings after the auto-tuning process.
Instructions for setting the desired target value (SV) for the controller.
Explains how to initiate and perform the auto-tuning process for optimal control.
For modifying environment parameters and tuning functionalities.
Configures initial parameters for overall control and functionality activation.
Used for first-time hardware configuration, requiring user caution.
Allows ignoring low alarms temporarily during initial temperature rise.
Details the 21 types of alarm outputs and their corresponding selection codes.
Explains the automatic tuning process to find optimal P, I, D values for load conditions.
Allows viewing the control output percentage (0-100%) in the SV display.
Covers setting alarm types, hysteresis, and delay times for two separate alarms.
Details how to output PV, SV, MV, or SPS as a 4~20mA current signal.
Explains functions like digital filters, input value correction, and decimal point setting.
Allows selecting hysteresis operation methods (NORM, HALF) for ON/OFF control.
Describes using external signals to switch between SV1 and SV2 set values.
Protects set values and functions from accidental changes via key operations.
To Next Page
