www.temcoline.com
DIGITAL PID CONTROLLER
Thank you for purchasing the T50 series from TemcoLine.
The T50 series is a precision industrial controller that uses an advanced 2
degree-of-freedom (DOF) algorithm.
The T50 series consists of 5 models, which are T52, T53, T54, T57, and
T59.This manual explains the installation, the functions, the operation,
and the handling of the products.
Please read the manual thoroughly before using the products. If any
difficulties arise while using our products, please call our customer service
at +82-1588-5439.
2
- Use the products under the conditions specified in this manual.
- Please heed the cautions and warnings listed in this manual.
- The contents of the manual may be changed without notice.
- The product is designed to be used installed on a control panel.
- This manual is copyrighted, and may not be copied in part or in whole
without permission.
- The manufacturer takes no responsibility for direct or indirect damages
caused by careless operation or operation under unpredictable or risky
environments.
Safety requirements are intended to prevent accidents and dangers
through the proper use of the products, so please heed them at all times.
The safety requirements are divided into "cautions" and "warnings", which
indicate the following.
WARNING
CAUTION
Pay attention to the followings!
Safety requirements!
Serious injury or death may be caused if instructions are not observed.
Failure to observe these instructions may cause damage to the instrument
or some injury to the user.
To Next Page
Loading...
Need help?
General
