TEMO 450 - Recharging Procedures; Recharging on Shore; Recharging on Board

ENG
29
1. RECHARGING ON SHORE
To charge the TEMO·450,useonlytheTEMOchargerandfollowthesesteps:
1. 
Removethemagnetickey.
2. T
urn the rotating ring located at the base of the handle to
uncover the charger inlet.
3. Insertthechargercableintothesocket.
4. Connect the charger to the shore power.
Pl
easeno
te:during the chargingprocess,thebaerylevelcannotbe
readontheluminousgaugelocatedonthehandleoftheTEMO
.
450
(asthekeyisdisconnected,themotorandtheluminousgaugeareno
longer powered).
Tocheckthechargingstatus,refertotheluminousgaugeonthecharger.
Itisredfortheduraonofthechargeandturnsgreenwhenthecharge
is completed.
Once the battery is charged, disconnect the charger, check turn
the rotating ring to cover and protect the charger inlet. Insert the
magnetic key into itsslot to check the battery level displayed
on the handle gauge.
2. RECHARGING ON BOARD
The TEMO
.
450canbechargedonaboatequippedwitha220V
installaonorwiththe12VTEMOcharger,availableasanoponal
accessoryintheaccessoriesrubricatwww.temofrance.com.