Name: Tempco TPC-1000
Brand: Tempco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Page 43 of 44

4 Factory Default Settings

The controller parameters can be loaded with default values listed in the parameter

description table. In certain situation it is desirable to retain these values after the parameters values has

been changed. The below procedure to be followed to reload the default values.

1. Ensure the LOCK parameter is set to NONE.

2. Press and hold for 6.2 seconds or until (Hand Control) appears on the

display.

3. Press key to navigate the manual mode menu to reach FILE.

4. Press and hold for 5 seconds or until the upper display FILE flash for a moment.

The default values of all parameters are now loaded.

Notes

______________________________________________________________________________________

Other manuals for Tempco TPC-1000

Questions and Answers:

Need help?

Do you have a question about the Tempco TPC-1000 and is the answer not in the manual?

General