a) Internet connection Type: Displays the current Internet connection type.
b) L2TP Server Address: Enter the IP address of a L2TP server.
c) User Name: Enter your L2TP username.
d) Password: Enter the password.
e) MTU: Maximum Transmission Unit. DO NOT change it from the factory
default of 1492 unless instructed by your ISP. You may need to change it for
optimal performance with some specific websites or application software that
cannot be opened or enabled; in this case, try 1450, 1400, etc.
f) Address Mode: Select "Dynamic" if you don’t get any IP info from your ISP,
otherwise select "Static". Consult your ISP if you are not clear.
g) IP Address: Enter the IP address provided by your ISP. Consult your ISP if
you are not clear.
h) Subnet mask: Enter the subnet mask provided by your ISP.
i) Gateway: Enter the WAN Gateway provided by your ISP. Consult your ISP if
you are not clear.
Note:
1. PPPOE, PPTP and L2TP cannot be used simultaneously!
2. For PPTP and L2TP Internet connections, only Static IP or Dynamic IP is
available.
3. Note that PPTP and L2TP may not be available on some products.
To Next Page
Loading...
