2. Configure Router 1:
1. Go to wireless section on Router 1 and specify WDS (or WDS Bridge) as its
wireless working mode.
2. Manually enter Router 2's MAC address (Also, you can use the Scan option
as mentioned above) and click OK to finish your settings.
2.4 Wireless Access Control
The Access Control feature allows you to specify a list of devices to Permit or
Forbid a connection to your wireless network via the devices’ MAC addresses.
All other devices not listed as Permitted will be Forbidden and vice versa.
1. Select the wireless network (SSID) you wish to enable Access Control on.
2. MAC Address Filter: Select Permit or Forbid from the drop-down list.
To Next Page
Loading...
