6 Tools
6.1 Reboot
Reboot the device to activate your settings. WAN connection will be
disconnected during reboot.
6.2 Restore to Factory Default Settings
Click the Restore to Factory Default button to reset device to factory default
settings. You need to reconfigure the device for Internet access as well as many
other settings including wireless settings.
The factory default settings are listed below:
IP Address: 192.168.0.1
Subnet mask: 255.255.255.0.
Note:
To activate your settings, you need to reboot the device after you reset it.
6.3 Backup/Restore
Backup: Once you have configured the device the way you want it, you can
save these settings to a configuration file on your local hard drive that can later
To Next Page
Loading...
