application on the LAN. This feature is enabled by default. No settings are
required.
Enable UPnP: Check/uncheck to enable/disable the UPnP feature.
OK: Click to complete your settings.
4.5 Static Routing
When there are several routers in the network, you may want to set up static
routing. Static routing determines the path of the data in your network. You can
use this feature to allow users on different IP domains to access the Internet via
this device. It is not recommended to use this setting unless you are familiar with
static routing. In most cases, dynamic routing is recommended, because this
feature allows the router to detect the physical changes of the network layout
automatically. If you want to use static routing, make sure the routerās DHCP
function is disabled.
1. Destination Network IP Address: Specify a single IP address, say,
172.17.0.100, or an IP net segment, .say, 192.168.88.0.
2. Subnet Mask: Specify a Subnet Mask that corresponds to the specified
destination IP.
To Next Page
Loading...
