3G 11N Wireless Router
56
to establish the connection.
Bridge Mode: You can wirelessly connect two or more
wired networks via this mode. In this mode, you need to
add the Wireless MAC address of the connecting device
into the Router's AP MAC address table or select one
from the scanning table.
Repeater Mode：In this mode, add the opposing MAC
address into each own AP MAC address table by manual
or scanner to enlarge and extend the wireless radio.
Encrypt Type: Select one from WEP, TKIP, AES for
security here.
Pass phrase: Enter the encrypted key for wireless
devices.
AP MAC Address: Input the MAC address of another
(opposing) wireless router you want to connect.
NOTE: It is recommended that two wireless
routers keep the same bandwidth, channel
number, and security settings. Apply the settings
and reboot the Router to activate it.
7.6 Wireless Access Control
To secure your wireless LAN, the wireless access control
is actually based on the MAC address management to
allow or block the specific clients to access the wireless
network. Select “Wireless Setting->Access Control” to
display the following screen:
To Next Page
Loading...
