4G680V2.0
21
3.7.2 WPS
WPS is the simplest way to establish a connection between the wireless clients and the wireless
router. You do not have to select the encryption mode and fill in a long encryption passphrase every
time when you try to setup a wireless connection. You only need to select enable on WPS
configuration and press a button on wireless.
WPS PBC authentication:
If your WIFI Enabled, Device supports WPS (WIFI Protected Setup) and you have forgotten
or do not wish to enter your password to connect to your 4G680V2.0, you may use the following
available procedures for quick access to WIFI.
Open the WPS:
WPS can be opened by two methods. The first method is Entering the management interface page,
press the ‘Apply ‘, open the WPS. It will continue 120 seconds. Like the following picture.
Select the SSID of the device and connect. Then you can see like the following picture.
To Next Page
Loading...
Need help?
General
