Power jack.
Used to connect to the included power adapter.
10/100/1000 Mbps auto-negotiation WAN port.
⚫
(Default) Under the Router mode, connect this port to a modem or an Ethernet jack.
⚫
Under the WISP or Universal Repeater mode, DO NOT connect any device to this port.
⚫
Under the AP mode, it functions as a LAN port.
10/100/1000 Mbps auto-negotiation LAN ports.
Used to be connected to computers, switches or game machines.
10/100/1000 Mbps auto-negotiation Ethernet port.
It is a LAN port by default. When the IPTV function is enabled, it can only serve as an IPTV
port to be connected to a set top box.
Used to start the WPS negotiation process, or to reset the router.
⚫
WPS: Press the button, and the WiFi LED indicator blinks slowly. Within 2 minutes,
enable the WPS function of the other WPS-supported device to establish a WPS
connection.
⚫
Reset: When the SYS LED indicator blinks, hold the button down for about 8 seconds,
and then release it when all the LED indicators light up. The router is restored to factory
settings.
To Next Page
Loading...
