144
The added rule displays in the bandwidth control list. The parameters on the picture below are
used for examples.
Parameters description
It specifies the additional information of the bandwidth control rule. This field is
required. For convenient management, you’d better specify different remarks for
different rules.
It specifies the IP address or IP address range of devices that this rule applies to.
If you want to control only one device, enter the same IP address in the two boxes. If
you want to control multiple devices, enter an IP address range including start IP
address and end IP address. The end IP address should be greater than the start IP
address.
It specifies the maximum upload/download rate of the device whose IP address is
within the IP Address Range.
It specifies the current status of the rule. You can enable or disable it as required.
Click to delete the rule.
8.3.2 Example of configuring bandwidth control
Networking requirement
The CPE is used to bridge to the ISP hotspot for internet access in a house in the countryside, and
the device is set to WISP mode. To ensure that every device can access the internet smoothly, you
want to specify a maximum upload/download for each device.
Assume that: The maximum upload rate of each device connected to the WiFi network of the
device is 5 Mbps, and download rate is 10 Mbps. And the IP address range of the devices
connected to the WiFi network is 192.168.2.100 to 192.168.2.200.
To Next Page
Loading...
Need help?
General
