Tenda I-WL-O3 - How to Manage the Device Remotely

51
3 Advanced Settings
Now you can access the device from the Internet by entering http://tenda.dyndns.org:8080 in
your browser.
How to Manage the Device Remotely
The Remote Web Access function allows the device to be configured and managed remotely from
the Internet via a web browser. Click Advanced > Network Service to locate the Remote Web
Access section. Note that this function is only available in WISP and Router mode.
Tip
1. For better security, customize a port number between 1024 and 65535 for the remote WAN
interface. Do not use the number of any common service port (1-1024) in case of conflicts.
2. Make sure your WAN IP address (Internet IP address) is a public IP address. Private IP
addresses are not routed on the Internet.
3. It is unsafe to make your device remotely accessible to all PCs on external network. For better
security, we suggest that only enter the IP address of the PC for remote management.
To access your device (WAN IP address: 102.33.66.88) at your home from the PC
(218.88.93.33) at your office via the port number 8080:
❶ Check the Enable box to enable the Remote Web Access function.
❷ IP Address: Specify the IP address for remote management (When it is set to 0.0.0.0, the
device becomes remotely accessible to all the PCs on Internet or other external networks. It is not
safe). In this example, enter 218.88.93.33.