2 Quick Installation Guide
❻ Make sure that the IP address is different from that of ISP hotspot and on the different network
segment. For example, if the ISP hotspot’s IP address is 192.168.2.x, this AP’s IP can be
192.168.5.x.
❼ Click Save to apply your changes. Wait until the device restarts automatically.
When the Bridge LED stays solid, it has been bridged successfully!
Repeater + P2MP Mode
Both the Repeater mode and P2MP mode support point-to-multipoint bridge connection. Only the
base device and remote device scan each other and keep their SSIDs, channels, security modes
and keys the same, can they bridge successfully. However, in P2MP mode, wireless clients are not
allowed to connect to the device itself. The device only works as a repeater to relay wireless
signal.
To Next Page
Loading...
