8
Scenario 2: Peer-to-multiple peers bridging
Step 1 Refer to Peer-to-peer bridging to make any two CPEs bridge to each other.
Step 2 Within 30 minutes after the peer-to-peer bridging succeeds, place the rest CPEs which are
in factory settings near the CPE with the LED1, LED2, and LED3 indicators solid on and
power them on. Wait about 1 minute. When the LED1, LED2, and LED3 indicators of these
new-added CPEs keep blinking, the peer-to-multiple peers bridging succeeds.
CPE 1: AP mode
LED 1, 2 and 3 indicators light
solid on
Client mode
LED 1, 2 and 3 indicators blink
Client mode
LED 1, 2 and 3 indicators blink
To Next Page
Loading...
Need help?
General
