How to Filter Access to Your Network
Click Wireless > Access Control to enter page below. This page allows you to specify a list of
devices to allow or disallow a connection to your wireless network via these devices’ MAC
addresses. To deactivate this feature, uncheck Enable; to activate it, check Enable and select
Forbid only or Permit only.
For Example: To only allow your computer at the MAC address of the A8:A6:68:14:8C:15 to
join your wireless network:
❶ Check the Enable box to enable the MAC Filter feature.
❷ Select Permit only as the Filter Mode.
❸ Enter the MAC address of the device you want to allow, say A8:A6:68:14:8C:15 and click
Add. If the MAC address of the device you wish to control its access has already connected to this
AP, you can directly click Select from the online device to add its MAC address.
❹ Click Save to apply your changes.
To Next Page
Loading...
