52
Parameters description
It specifies the working mode of this device.
Repeater mode: In this mode, the device can connect 2 or more (this device supports 4
at most) wired networks with a wireless link, and can be connected with both wired and
wireless clients. To use the Repeater function of this device, the peer AP is required to
support WDS function, and use the same radio band as that of this device.
It specifies the wireless network name (SSID) of the peer AP.
It specifies the operating channel of the WiFi network to be bridged. It will be
automatically populated when you select an SSID to bridge.
It specifies the security mode of the WiFi network to be bridged. It will be automatically
populated when you select an SSID to bridge.
The Repeater mode only supports WEP and None security modes.
Configuration procedures of peer to multiple peers briding
Assume that the related parameters are shown as follows:
CPE1:
− IP Address: 192.168.2.1
− SSID: Tenda_123456
− Channel: 165
− Security mode: None
To Next Page
Loading...
Need help?
General
