3 FAQs
Q: I enter the device’s LAN IP address in the web browser but cannot access this device’s
web UI. What should I do?
1) Verify that the IP address of computer should be a different one but on the same network
segment as the LAN IP address of this device. The default LAN IP address of AP is 192.168.2.1
and you need to set your PC to a static IP address within the following range: 192.168.2.X
(2~253);
2) Clear the browser cookies or try another web browser;
If you are still unable to login, please restore the device to factory default settings and follow this
Install Guide to configure your settings again.
4 Safety and Emission Statement
CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause radio interference, in
which case the user may be required to take adequate measures. This device complies with EU
1999/5/EC.
NOTE: (1) The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. (2) To avoid unnecessary radiation interference, it is
recommended to use a shielded RJ45 cable.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
To Next Page
Loading...
